They went on Ez!. Jus clean all surfaces b4 application.. Great look

These turned out a bit better than I expected. Wanted something I could use to black out this section of the rear lights without permanently painting the lenses, and it definitely does the job.Most of us are probably DIY buyers, so a couple of install tips I picked up on the fly:1) Make sure you apply plenty of water with a spray bottle to both sides of the overlay, as well as the surface of the lenses while you're applying/aligning the pieces. If you don't lay it perfectly the first time, you can lift the overlay back up and respray until you get tue desired alignment.2) Don't be afraid to use your hands. After I minimally scratched the first piece I placed and adhered, I switched from a felt wrap squeegee to a good ole' elbow grease and finger strength to push the remaining bubbles out of the overlay (spraying with water often to keep the surface slick). I did still use the squeegee to push large bubbles out while getting my placement right.3) Use minimal heat. If you have a hair dryer I would almost suggest using it versus a heat gun. Again, trial and error after applying too much heat and too early. You should only need the heat after the overlay is mostly placed. Try to work out as many air bubbles as possible before using a heat source (unless you need to use heat to stretch the vinyl for fitment).4) Patience and attention to detail is key. Upon first glance, I was not satisfied with the look of these. I thought they looked rippled and too bubbly/foggy. The instructions warn of this with the same message: don't fret. I realized within several hours that the overlay began to adhere fully. After 24 hours there were still a couple of small bubbles I wanted to work out, so I re-applied some moisture/heat and got them looking great.Overall would definitely recommend the product for the price and ease of use!

These were easy to install and they stay on well. Comes with two sets of each in case you mess up. They look good on my Stinger!

A little awkward to fit but really enhances the look of your car

Rear Side Markers Reflectors Tail Light Precut Smoked Vinyl Tint Fits Kia Stinger GT 2018-2021

But these do not fit the 2022 tails lights only the side reflector just to let the 2022 owners know

Works as promised, installation requires being careful, that's hey why there are two set of two. Few months in adhesion is perfect includingultiple car washes.

The product fit properly and was easily installed.

Everything was good except the long pieces for the side reflectors aren't long enough. They leave about an inch un covered

Great look.. Thanks!!

2 strikes for side markers and rear reflectors being wrong size. Product easy to install

Really changed the look of my taillights.

If you don't want to watch the video let me summarize:Side pieces as other people say; DO NOT... Fit completely. Recommend cutting off from the second sheet you get and adding that extra inch on, cutting it and shrinking it on the side.Back two light pieces are fine, won't require stretching. BUT.. make sure you use a CLEAN. Microfiber towel or even a new one as even the smallest dust particles will create bubbles that you can't get out.If they made they made the side pieces fit to scale, would be a 4- star. But so far for installation, not hard although... you will have to fight with it for a little bit.Update: Vendor sent me another pair to fix and update mistakes, warranted 5-star review for excellent service.

The side ones are too small so I had to cut pieces out of the second set, it's ok, worth the price I guess but I just don't see why they aren't made to size

Easy to install and awesome that they sent an extra set. Very easy to work with as well. Great seller!