Alcantara Installation Instructions:

1. Wipe down and clean the surface area where the decal will go. First clean with soapy water and then with rubbing alcohol to remove all dirt, debris and oils. Allow to dry.  Note: Make sure that all coatings ,waxes, ceramic coatings, etc., are removed to allow the decal to properly adhere.
2. Peel off the decal from the backing paper (having an extra set of hands is highly recommended).
3. Align/position the decal starting on one end and carefully apply over the door panel trim (decal is removable and can be repositioned). There may be excess material that will be tucked in or trimmed after placement of the decal is complete.
4. Use your fingers or a felt tipped squeegee to press the vinyl trim firmly as you go across the door panel trim to help it adhere. Note: Make sure to squeegee the decal thoroughly to prevent bubbles from forming. 
5. Once the decal is aligned and placed, press firmly and gently rub the decal while applying heat (heat gun or hair dryer) to assist with adhesion. Heat allows the decal to mold onto the shape it is being place on.
6. Using a credit card or squeegee, tuck in the vinyl trim into the edges/corners. Using a blade trim any remaining excess material if any.

If you are having any issues, please feel free to reach out to us. We understand installation can sometimes be difficult. We are here to help. 

Using heat always help with installation.

Want to get featured?